18. Common Reference System
18-6
18.3.2 How to set usage rights as "multi" or "slave"
Multiple workstations can be selected to control monitoring modes and navigation sensors. This means that these
particular workstations are used to select route, user chart and Notes for monitoring modes. However, the multiple
control requires that none of the other workstations is set for Master usage rights. If the other workstation is set for
Master usage rights, then this workstation can be set only as Slave or Plan. The transition from Slave to Multi usage
right is automatic. If later the usage right selections in the other workstation are changed, then the usage rights in
this workstation is automatically set as Multi or Slave based on non-existence or existence of a Master usage rights
workstation.
To configure the system so multiple workstations have usage
rights set as Multi, do the following:
1. On the workstation for which you want to give Multi or
Slave usage rights, put the cursor below the Lost TGT
alarm indication, confirm that Initial Settings is shown in
the mouse functions area then push the right mouse button.
2. Check the Usage rights box and select either Multi (Slave)
or Slave (Multi) from the List box. First alternative
indicates the selection and second alternative in parenthesis
indicates the provisional selection. Provisional selection
may be used by the system if new usage rights selections
are made in the other workstation.
If, based on your request, you got shared Multi usage rights,
then the indication MULTI appears at the lower right-hand
corner of display. If one of the workstations was already
selected as Master, then the system cannot give you Multi
usage rights. In this case the indication SLAVE appears at the
lower right hand corner of display.
NM
NM
OR
To Next Page
Loading...
