29-1
29. Conning Display
29.1 System Configuration
The ECDIS can receive data from various sensors. It can adopt information output by the sensors in either analog or
digital format, make navigation calculations from the data display and show the results on the conning display
(option).
The ECDIS can be connected to up to16 sensors (two LAN adapters, eight sensors/adapter), which output analog
data and up to eight sensors that output serial data.
Data displayed on the conning display depends on the settings in the ECDIS and the conning display configuration
set in the installation parameters, where you can arrange the layout of the conning display.
There are six predefined places on the conning display where you can specify data to display. The center of the
conning display is fixed to show information defined by the manufacturer. For more information about how to
process these windows, see the description of the installation parameters in the installation manual.
The figure below shows the locations of operator-defined windows. The content of the windows are defined in the
installation parameters.
Conning display
To Next Page
Loading...
