10. Manual Updates
10-11
10.6 Manual Update Editor with True Symbols
The manual update editor has the following features:
• Planning: Operate with new manual updates.
• Undo Last: Remove last accepted manual update planning session. By repeating
Undo Last you can remove any amount of old manual update planning session.
• Clear: Remove all manual updates in a single operation.
• Backup and Restore: Make a backup or to recall already recorded backup.
With an ARCS chart, you also have "Set chart viewing dates" to set viewing date of
manual updates. This is done with "Set Chart viewing dates" in the Chart menu.
10.6.1 How to plan manual updates
The manual update editor operates in sessions. You create a session when you activate the Manual Update Planning
dialog box. You can freely delete, modify, copy or create chart objects until you feel finished with your session.
Then, you terminate your session by clicking the Accept Manual Updates as Permanent button and the ECDIS
stores your manual updates permanently. If you need to leave your manual update session and discard all
modifications made during the current session, click X in upper right corner.
Note: The manual update editor is only available in the North Up or Course Up orientation mode.
New, Copy, Modify, Delete: These buttons are used to collect chart objects into a list shown in a Manual Update
Planning dialog box for further editing during current session of manual update planning. New creates an object
from scratch. Copy creates an object using an existing object as an example. Modify changes an existing object.
Delete removes an existing object.
Remove from List: If you made a manual update by mistake, you can remove it if you haven't accepted it yet as
permanent. You can remove it by choosing (highlighting) chart object in the List then clicking this button.
Edit Properties: You can edit properties of selected (highlighted) chart object by using this button.
To Next Page
Loading...
