Furuno FEA-2807 - Use of ECDIS Display for Conning Display; How to Activate Conning Display

29. Conning Display
29-14
29.4 Use of ECDIS Display for Conning Display
If you have only one monitor, it is possible to use it for both an ECDIS display and a Conning display, if ECDIS
software installation has been done for "ECDIS with Conning Display (1 display unit)". Then you can switch
between ECDIS display and Conning Display.
29.4.1 How to activate conning display
To enable swapping between ECDIS display and Conning Display you have to configure "Conning Display"
function to one of four function keys. Below is example where F2 is used to activate Conning Display on ECDIS
monitor.
To switch ECDIS display to Conning Display, press F2 key (this example) on Control Head. If you want to back to
ECDIS display you can press any key except Alert Ack. Or System Failure on Control Head.