16. Notes
16-4
16.3 How to Select Notes to use in Monitoring Mode
Do as shown below to select Notes for use in the monitoring mode.
Place cursor here,
spin scrollwheel to
choose Notes and
push scrollwheel.
Select Notes
Monitor
Plan
X
DISP
DISP
(WT)
16.4 How to Send Notes to the Radar Screen
If ECDIS workstation is set as SINGLE mode, you have to define on the Radar Selection dialog box if the ECDIS
sends Route, User Chart and Notes to the radar. When Route, User Chart or Notes is selected to the Monitor mode,
information of Route, User Chart and Notes are sent to radar if "Send to Radar" is set "ON".
(WT)
To change "Send to Radar" to ON or OFF, do the following:
1. Put the cursor on Radar in the status bar to show the Radar selections dialog box.
2. Put the cursor on ON (OFF) text in the "Send to Radar" field.
3. Spin the scrollwheel to select ON or OFF then push the scrollwheel.
To Next Page
Loading...
