14. Route Monitoring
14-4
14.6 How to Display a Route on the Electronic Chart
Screen
To display a monitored route, make sure that desired options of the monitored route (center line, channel borders,
WPT marks, leg marks and wheel over line) are selected on the Route page of the Chart Display dialog box.
To show this display, spin the scrollwheel to show Symbol Display/Info/ in the
mouse functions area, push the left mouse button then click an arrow tab to display
the Route menu.
"WPT mark"enables display of a waypoint's number in a route.
"Leg marks" enables display of planned speed and planned course to steer in a route.
"Wheel over line" enables display of a line that denotes turn start line for a
waypoint. This line appears when "WPT approach" is coming and disappears when
turning has started.
14.7 How to Show a Route on the Radar Screen
If an ECDIS workstation is set as SINGLE mode, you have to define in the Radar Selections dialog box if the
ECDIS is to send Route, User Chart and Notes to the radar. When Route, User Chart or Notes is selected to Monitor
mode, information of Route, User Chart and Notes are sent to the radar if "Send to Radar" is set to "ON".
(WT)
To change "Send to Radar" to ON or OFF, do the following:
1. Put the cursor on Radar in the status bar to show the Radar selections dialog box.
2. Put the cursor on ON (OFF) text in the "Send to Radar" field.
3. Spin the scrollwheel to select ON or OFF then push the scrollwheel.
To Next Page
Loading...
