6. Setup Before Departure
6-3
6.3 How to Check and Prepare Route to Monitor
Select a route for the next voyage: select Route from the menu then click the Monitor button. See section 14.2
"How to Select Route to Monitor".
Average SPD
If the text "Checked conditions differ" appears in the dialog box, this means that conditions
selected during route planning were different than those selected for use during route
monitoring. See section 6.3.3 "How to confirm checked conditions of the route plan" and
section 6.3.4 "Planned user chart".
6.3.1 How to select To WPT
The system selects a To WPT automatically. Check that it is the correct one. Note that waypoint number 1 is not
accepted. Use the Monitor Route dialog box to select a waypoint.
6.3.2 How to select final waypoint
This selection is used ONLY when the last waypoint should be different than the one defined last in your route. If
necessary, use the Monitor Route dialog box to select the final waypoint.
To Next Page
Loading...
