Furuno FEA-2807 - ROT Sensor; Sensor-Related Alerts

19. Navigation Sensors
19-22
19.13 ROT Sensor
You can get an alert when the ship's ROT is above the
specified ROT. Open the Sensors dialog box and click
the Count/ROT tab. Enter the limit in the Rot Alert input
box.
When the ROT is higher than the value specified for 10
seconds the alert "819 ROT over limit" appears.
If the ROT stays lower than the specified value for 30
seconds after the acknowledgement of the alert, the alert
indication is erased.
On the conning display, the ROT indication is red when
the ROT Alert function is active and the ROT is higher
than the set value.
19.14 Sensor-related Alerts
The following alerts, which are not described elsewhere, are related to sensors.
"355 Radar Comm. Error": Lost connection to radar 1. As a consequence the system loses Tracked Targets and
speed/course available from radar.
"356 Radar Comm. Error": Lost connection to radar 2. As a consequence the system loses Tracked Targets and
speed/course available from radar.
"357 Radar Comm. Error": Lost connection to radar 3. As a consequence the system loses Tracked Targets and
speed/course available from radar.
"358 Radar Comm. Error": Lost connection to radar 4. As a consequence the system loses Tracked Targets and
speed/course available from radar.
"371 Radar source changed": Lost connection to the radar that is the source Tracked Targets and speed/course
information. Then, if other radars exist, the system selects one of them as the new source of Tracked Targets and
speed/course information and the system generates alert 371.
"701 B-Adapter Error": Lost connection to B-Adapter, which is an interface to various navigation sensors.
"702 Engine Control Comm Error": Lost connection to engine control, which could be an interface to various
navigation sensors.
"705 Gyro Error": Lost connection to gyro1 sensor.
"706 Gyro Error": Lost connection to gyro2 sensor.
"708 Log Error": Lost connection to log sensor.
"709 Dual Axis Log Error": Lost connection to dual-axis log sensor.
"710 Echo Sounder Error": Lost connection to echo sounder sensor.
"711 Wind Sensor Error": Lost connection to wind sensor.
"712 Position Eq Error": Lost connection to position sensor No. 1.
"713 Position Eq Error": Lost connection to position sensor No. 2.