Furuno FEA-2807 - Page 277

15. User Chart Control
15-3
User chart dialog box and menu
Click UserChart in the information area then click Plan or Monitor button to open corresponding dialog box. If no
User Chart has been selected, one of the menus shown below appears, along with appropriate dialog box.
If you want to make further selection from a menu and only the dialog box is shown, you can show the menu on the
display by clicking the Plan or Monitor button again, or put the cursor on the triangle in the dialog box.
[User Chart]
Go Monitor mode
Select
Unselect
Create
Backup and Restore
Combine
Point report
Line report
Area report
Symbols report
Tidal report
Full report
Report for radar
Close
[User Chart]
Go Plan mode
Select
Unselect
Backup and Restore
Point report
Line report
Area report
Symbols report
Full report
Report for radar
Close
Go Monitor(or Plan) mode: The operator can switch user chart mode between plan
and monitoring modes with Go Monitor(Plan) mode on the menu. Push the
scrollwheel to show the sub menu shown below.
Go Monitor mode>Go Monitor mode: User chart used in planning mode can be
switched directly to monitoring mode.
Go Plan mode>Go Plan mode: User chart used in monitoring mode can be
switched directly to planning mode.
Select: Select user chart to use.
Unselect: Remove current user chart from active use.
Create: Create a new user chart.
Backup and Restore: Make backup copy of user chart or restore user chart from
backup device.
Combine: Combine two or more user charts.
Point report: Generate report about points in a user chart.
Line report: Generate report about lines in a user chart.
Area report: Generate report about area objects in a user chart.
Symbols report: Generate report about symbols in a user chart.
Tidal report: Generates report about tides in a user chart.
Full report: Generate report about all the objects in a user chart.
Report for radar: Generate report about all the objects in a user chart that are
displayed on the radar screen.