Furuno FEA-2807 - Page 37

3. ECDIS Display
3-9
Information in autopilot sidebar
The following information is shown in the autopilot sidebar.
• Steering mode (below "Autopilot")
• Prog CRS: If you use program track or program
heading change steering modes, planned course is
shown.
• Set CRS: Actual set course
• Set HDG: Actual set heading
• Radius: Actual set radius
• ROT: Value for ROT
• Cond: Setting for loading condition
• Perf: Setting for steering accuracy
• Off track: Distance from center line of planned
route
Information in conning display sidebar
The following information is shown in the conning display sidebar:
• ROT indicator
• Heading indicator
• Speed indicators
• Longitudinal speed and source of speed
• Transversal speed
• Rudder angle indicator
Transversal
speed (frwd)
Longitudinal
speed
Transversal
speed (aft)
kn
kn
kn
Information in docking sidebar
The following information is shown in the docking sidebar:
• ROT indicator
• Heading indicator
• Speed indicators
• Longitudinal speed and source of speed
• Transversal speed
• Rudder angle indicator
• Depth below transducer
• On bow
• On stern
Transversal
speed (frwd)
Longitudinal
speed
Transversal
speed (aft)
Depth
(bow)
Depth
(stern)
Depth
kn
kn
kn
Information in chart legend sidebar
For detailed information see the chapters on vector charts and raster charts.