GE Voluson E Series - TCP;IP Configuration

3.13.1 TCP/IP Configuration
Note
Following information must be provided by the customer or hospital engineer before you can start: Station
name, AE Title, IP address and Port Number for the Voluson E-Series. The IP addresses for the default
gateway and other routers at the site for ROUTING INFORMATION. Only if necessary (e.g. for Internet
access).
1. Press the Utilities key on the control console.
2. In the “Utilities” menu touch the Setup button to invoke the setup desktop on the screen.
3. On the right side of the screen select Connectivity and then click the Device Setup tab.
4. Click the button, read the message and confirm with Yes .
Figure 3-44 Configuration
5. The "Internet Protocol (TCP/IP) Properties" dialog page appears.
Note
This example shows fictional numbers!
Figure 3-45 Internet Protocol (TCP/IP)
1 You can get IP and DNS settings assigned automatically, if your network supports this capability.
2 If fixed IP address is required, ask your network administrator for the appropriate settings.
Type in:
-
IP address
-
Subnet mask
-
Default gateway
-
DNS server
Note
For further details refer to the Voluson E-Series Basic User Manual.
Setup Instructions
3-58
Voluson E-Series Service Manual
5539550APB Revision 6