GE Voluson E Series - Adjustment of Printer Settings

3.6.5 Adjustment of Printer Settings
After system restart:
1.
Press the Utilities key on the control console.
2. In the “Utilities” menu touch the
Setup button to invoke the setup desktop on the screen.
3. On the right side of the screen select Connectivity and then click the Peripherals tab.
4. Select the desired printer from the Printer Settings pull-down menu and click the Edit button.
Figure 3-29 select desired printer
•
"UP-D897 / UP-D898MD Printer - Settings" on page 3-38
•
"UP-D25MD Printer Settings" on page 3-39
Warning
After each installation, the leakage currents have to be measured according to IEC 60601-1, IEC 62353 or
other relevant standard.
3.6.5.1 UP-D897 / UP-D898MD Printer - Settings
1.
Call up the "Printer Preferences"; see
Section 3.6.5 "Adjustment of Printer Settings" on page 3-38 .
2. Select the Layout page and select:
-
Paper: 960x1280
-
Orientation: Portrait
-
Interpolation Method: Bilinear
Figure 3-30 Layout / Density Adjust page
3. Select the Density Adjust page and select:
-
Gamma: TONE2
-
Advanced = 0, Dark = 0, Light = 0, Sharpness = 2
4. Save the adjusted printer settings with Apply and OK . Close window and exit System Setup.
5. Assign the printer to the remote keys P1, P2, P3, P4, P5 and/or P6; see Section 3.6.6 "Remote Control
Selection" on page 3-41 .
Setup Instructions
3-38
Voluson E-Series Service Manual
5539550APB Revision 6