GE Voluson E Series - 8.14 Replacement of the Caps for Encoders and;or Joycoders

8.14 Replacement of the Caps for Encoders and/or Joycoders
Manpower
One person, 10 minutes
Tools
none (poss. small-sized slotted screwdriver or tweezers)
8.14.1 Caps for Encoders and/or Joycoders - Replacement Procedure
1.
Remove the caps for Encoders and/or Joycoders.
Note
Do not loose integrated metal spring in each cap.
Figure 8-31 remove caps
2. Mount the caps for Encoders and/or Joycoders.
Replacement Procedures
Voluson E-Series Service Manual
5539550APB Revision 6
8-25