GE Voluson E Series User Manual

3.7.1.6 How to change Video Norm
1.
Invoke System Setup as described in Section 3.7.1.1 on page 3-43 .
2. On the right side of the screen select Connectivity and then click the Peripherals tab.
3. Click the proper field: PAL (50Hz) or NTSC (60Hz); see Figure 3-28 on page 3-37 .
4. Close the Service page with Save&Exit and restart the system.
3.7.1.7 How to change Ext. Monitor Output Settings
1. Invoke System Setup as described in Section 3.7.1.1 on page 3-43 .
2. On the right side of the screen select Connectivity and then click the Peripherals tab.
3. If not currently selected, click the proper field; see Figure 3-28 on page 3-37 .
4. Close the Service page with Save&Exit and restart the system.
3.7.1.8 How to adjust function of the Footswitch
1. Invoke System Setup as described in Section 3.7.1.1 on page 3-43 .
2. On the right side of the screen select Connectivity and then click the Peripherals tab.
3. Select desired function of the Footswitch. Refer to Figure 3-28 on page 3-37 .
4. Close the Service page with Save&Exit and restart the system.
3.7.1.9 How to change the Keyboard Layout
see
Section 6.4 "Modification of Keyboard Layout" on page 6-5
3.7.1.10 How to configure InSite
see
Section 3.13.8 "InSite Configuration" on page 3-70
3.7.1.11 How to execute Additional Software Installation (ASI)
1. Invoke System Setup as described in
Section 3.7.1.1 on page 3-43 .
2. On the right side of the screen select Administration and then click the Service tab.
3. Enter the password « she » and click Accept .
Entering a password is no more required at systems with software version EC330 (BT18).
4. Click the
ASI button.
The software parts to be installed depend on the contents of the System DVD that is used.
Setup Instructions
Voluson E-Series Service Manual
5539550APB Revision 6
3-45

GE Voluson E Series Specifications

General

Brand	GE
Model	Voluson E Series
Category	Medical Equipment
Language	English