5. Select the
Option
tab to see which options are currently installed. Please print out the options page or
write down down the state of the options (P = permanent, I = inactive).
Note
It is not necessary to note the Permanent Key; it is the state of the option that matters.
Figure 8-2 System Setup - Administration - Options page
1 D = Demo (Option is activated for demo and expires at date shown in the "Valid" column)
I = Inactive (Option is not activated)
P = Permanent (Option is permanently activated, i.e.purchased)
d = deactivated
(Option is inactive)
2 Permanent Key
Note
If the currently installed software has to be upgraded to a newer version, and the system is updated via the
FMI from DVD button, a new software specific “Permanent key" is required. Please contact your local
distributor or GE service representative.
Replacement Procedures
Voluson E-Series Service Manual
5539550APB Revision 6
8-5
To Next Page
Loading...
