GE Voluson E Series - Page 66

Connection to work within the Network Environment
The Color Laser Printer can be connected to work within the network environment. Usually this will be the
hospital network.
Physical connection:
Two network cables are needed.
1.
Connect the Color Laser Printer.
-
Connect the first network cable to the Ethernet LAN connector on the Voluson E-Series system.
The other end connect to a hospital network wall outlet.
-
Connect the second network cable to the Ethernet connector of the Color Laser Printer. The other
end connect to a hospital network wall outlet.
-
Connect the power cable of the printer to an external, non-isolated power source.
Figure 3-14 Connection Scheme - Color Laser Printer (within Network Environment)
Setup Instructions
3-22
Voluson E-Series Service Manual
5539550APB Revision 6