156
Program description - Phase settings | Winged models
Phase 1
Phase 2
Phase 3
Phase 4
Phase 5
Name Timer
Sw. time
Motor
0.1s
yes
0.1s
yes
0.1s
yes
0.1s
yes
0.1s
–
–
–
–
Normal
Launch
Dist.
yes
Following a brief tap on the centre SET key of the
right touch pad, the switchover time value in the field
displayed in inverse video can be changed within a
range of 0 and 9.9 s.
Example:
Phase 1
Phase 2
Phase 3
Phase 4
Phase 5
Name Timer
Sw. time
Motor
0.1s
yes
0.1s
yes
1.1s
yes
0.1s
yes
0.1s
–
–
–
–
Normal
Launch
Dist.
yes
The switchover time from any other phase to Phase 1
«normal» will take 2.2 s.
The time for a switchover from, for example, Phase 1
to Phase 3, is set to 1.1 s and the time for a switchover
from Phase 1 or 3 to Phase 2 "Launch" is 1.5 s.
Such asymmetric transition times can be useful when,
e. g. switching between extremely different flight phas-
es, such as between aerobatics and normal flight.
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset the time in the cur-
rently active value field back to 0.1.
Note:
The "switch time" set here applies uniformly
to all settings that are specic to ight
phases, and thus to all mixers activated in the
»Wing mixers« menu, see page 172.
Accordingly, the transition between ight phase-
specic mixers does not occur abruptly. However, if
individual servos are to be switched without a delay
then these can be dened accordingly in the »Non-
delayed chan« menu (see page 163).
To Next Page
Loading...
