232
Program description - Teacher/pupil
touch pad …
TRAINER /student
P
T
2 3
4
5
BIND:
SW:
1
Binding
6 7 8 9 10
11 12
–––
… and repeat this immediately on the teacher trans-
mitter:
TRAINER /Teacher
P
T
2 3
4
5
BIND:
SW:
1
Binding
6 7 8 9 10
11 12
9
As soon as this process is complete, both screens will
show "ON" instead of the fl ashing "BINDING":
TRAINER /student
P
T
2 3
4
5
BIND:
SW:
1
on
6 7 8 9 10
11 12
–––
TRAINER /Teacher
P
T
2 3
4
5
BIND:
SW:
1
on
6 7 8 9 10
11 12
9
You can return to the basic display on both screens
and start the training session after carefully checking
all of the relevant functions.
If neither transmitter or only one transmitter displays
"ON", this means the binding process has failed: try
changing the positions of both transmitters and then
repeat the entire procedure.
Important notice:
Check that the model aircraft is
operational and check that all
functions issue the correct
commands BEFORE setting up trainer
mode.
During the …
Training session
… the teacher and pupil can maintain a variable dis-
tance from one another. But you should stay “within
earshot” (max. 50 m) under any circumstances,
however, no one else should be standing between
the teacher and the pupil since these persons could
reduce the connection range of the return channel
used by the two transmitters.
In this operating mode, the basic display of the teach-
er transmitter is as shown below …
#01
0:24h
Stop watch
Flight tim
K78
0:00.0
3.9V
0:00.0
00
0
0
1:23h
P
V
RFC–Teacher
Graubele
… and the pupil transmitter's display will look some-
thing like this:
#01
0:24h
Stop watch
Flight tim
K78
0:00.0
3.7V
0:00.0
00
0
0
4:32h
RFC–student
Schüler
If, however, the connection between the teacher and
pupil transmitters should be lost during the training
session, then the teacher transmitter will automati-
cally assume control of the model.
If the trainer mode switch is in the "Pupil" position
when connectivity is lost, the
Warning LED on
the teacher transmitter will blink and audible warning
signals will also be sounded for as long as the signal
is lost. The basic display also displays the following
warning notice:
No
pupil
signal
However, if only the character string "HF –" blinks on
the transmitter's basic display accompanied by the
audible warning signals, the pupil signal has been
lost but the trainer mode switch is set to the "Teacher"
position.
In both cases, your fi rst step should be to reduce the
To Next Page
Loading...
