GRAUPNER mc-32

311
Programming examples - Using ight phases
Aileron differential
Brake settings
+33%
Aileron
+55%
WING MIXERS
Elevator
aileron
0%0%
–––
–––
rudder
2
3
4
5
Normal
Note:
The list of displayed options depends on the
number of servos entered in the "Ailerons/
aps" line in the »Model type« menu, in
this example “2 AIL”.
Now switch to the sub-menu and enter the raised
height of aileron brakes for individual flight phases in
the “Crow” line.
With “Diff. reduct.” (differentiation reduction), you
should enter the value previously set in the aileron
differentiation line in order to suppress it again while
breaking.
In the “Elevat. curve” sub-menu, enter a correction
value for the elevator, see page 186 and 187.
Elevat. curve
BRAKE SETTINGS
Normal
Crow
AILE
WK2
0%
WK
0%
Diff. reduct.
+30%
+30%
Note:
The "Brake settings" sub-menu of the »Wing
mixers« menu is switched "off" when: for
the "Motor at C1 front/rear" column of the
»Model type« menu (page 104) AND for the
"Motor" column of the »Phase settings« menu
(page 154), a "yes" is entered for the currently active
ight phase. Change the ight phase, if applicable.