6-4
Field Description
Last clearing of counters
Time when statistics on the logical interface were last cleared by
using the
reset counters interface
command.
If the statistics of the interface have never been cleared by using
the
reset counters interface
command since the device starts,
Never
is displayed for this field.
Last 300 seconds input: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average input rate over the last 300 seconds, where:
packets/sec indicates the average number of packets
received per second.
bytes/sec indicates the average number of bytes received
per second.
bits/sec indicates the average number of bits received per
second.
Last 300 seconds output: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average output rate over the last 300 seconds, where:
packets/sec indicates the average number of packets sent
per second.
bytes/sec indicates the average number of bytes sent per
second.
bits/sec indicates the average number of bits sent per
second.
0 packets input, 0 bytes, 0 drops
Total number and size (in bytes) of the input packets of the
interface and the number of the dropped packets
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of the output packets of the
interface and the number of the dropped packets
The brief information of interface(s) under
route mode:
The command displays brief information about Layer 3
interfaces
Link: ADM - administratively down; Stby -
standby
AMD
indicates that the interface has been shut down by the
network administrator. To recover its physical layer state,
perform the
undo shutdown
command.
Stby
indicates that the current interface is a standby interface.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as
UP, but its link is an on-demand link or not present at all, its
protocol attribute includes the spoofing flag (an
s
in
parentheses).
Interface Interface name