EasyManuals Logo

H3C S7500E Series Command Reference

H3C S7500E Series
368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #186 background imageLoading...
Page #186 background image
9-3
Output (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
# Display brief information about Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> display interface bridge-aggregation 1 brief
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface Link Speed Duplex Type PVID Description
BAGG1 DOWN auto A A 1
# Display information about all Layer 2 aggregate interfaces in DOWN state.
<Sysname> display interface bridge-aggregation brief down
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
BAGG1 ADM Administratively
Table 9-1 display interface bridge-aggregation command output description
Field Description
Bridge-Aggregation1 current state
The Layer 2 aggregate interface status, which can be:
DOWN ( Administratively ) – The interface is administratively shut
down with the shutdown command.
DOWN – The interface is administratively up but physically down
(possibly because no physical link is present or the link is faulty).
UP – The Ethernet interface is both administratively and physically
up.
Unknown-speed mode,
unknown-duplex mode
The interface speed and duplex mode are unknown.
PVID The default VLAN ID.
Last clearing of counters
Time when the
reset counters interface
command was last used to
clear the interface statistics.
Never
indicates the
reset counters interface
command has never been
used on the current interface since the device’s startup.
Last 300 seconds input/output The average input/output rate over the last 300 seconds.
Input/Output (total) The statistics of all packets received/sent on the interface.
Input/Output (normal) The statistics of all normal packets received/sent on the interface.

Table of Contents

Other manuals for H3C S7500E Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S7500E Series and is the answer not in the manual?

H3C S7500E Series Specifications

General IconGeneral
BrandH3C
ModelS7500E Series
CategorySwitch
LanguageEnglish

Related product manuals