H3C S7500E Series - Page 88

2-29
To use the interface command to enter ONU port view, use the using onu command to create the
corresponding ONU port first.
Examples
# Create ONU 3/0/1:5 whose sub-channel number is 5 for OLT 3/0/1.
<Sysname> system-view
[Sysname] interface olt 3/0/1
[Sysname-Olt3/0/1] using onu 5
Please wait…Done.
# Create ONU ports whose sub-channel numbers are 1 to 5 for OLT 3/0/1.
<Sysname> system-view
[Sysname] interface olt 3/0/1
[Sysname-Olt3/0/1] using onu 1 to 5
Please wait….Done.
[Sysname-Olt3/0/1] display brief interface onu
The brief information of interface(s) under bridge mode:
Interface Link Speed Duplex Link-type PVID
Onu3/0/1:1 DOWN -- -- access 1
Onu3/0/1:2 DOWN -- -- access 1
Onu3/0/1:3 DOWN -- -- access 1
Onu3/0/1:4 DOWN -- -- access 1
Onu3/0/1:5 DOWN -- -- access 1