IconMaster Installation and Configuration Manual 87
Chapter 4: Router Connections
3. Use the toggle switch (Nav) to scroll through the parameter list until Setup
is highlighted.
4. Press the right (Sel) button.
5. Use the toggle switch (Nav) to scroll through the parameter list until Nav
Mode is highlighted.
6. Press the right (Sel) button.
7. Use the toggle switch (Nav) to scroll through the parameter list until All
List is highlighted.
8. Press the right (Sel) button.
9. Press the left (Esc) button.
10. Press the left (Esc) button again.
11. Use the toggle switch (Nav) to scroll through the parameter list until XY
Level is highlighted.
12. Press the right (Sel) button.
13. Use the toggle switch (Nav) to scroll through the values until 2 (on the first
NSM) or 3 (on the second NSM) is reached.
14. Press the left (Esc) button to set the value.
15. Use the toggle switch (Nav) to scroll through the parameter list until
SrcOffset is highlighted.
16. Press the right (Sel) button.
17. Use the toggle switch (Nav) to scroll through the values until 1 is reached.
18. Press the left (Esc) button to set the value.
19. Use the toggle switch (Nav) to scroll through the parameter list until
DestOffset is highlighted.
20. Press the right (Sel) button.
21. Use the toggle switch (Nav) to scroll through the values until 0 is reached.
22. Press the left (Esc) button to set the value.
To Next Page
Loading...