138 IconMaster Installation and Configuration Manual
Chapter 7: Automation Setup
Switcher Configuration in bus.tbl
To allow the IconMaster to receive switching requests for events on a specific
bus, there must be a corresponding entry in the bus.tbl record to map the
D-MAS switching level on that bus to the IconMaster: (The switcher number
field has the swr.tbl index of the IconMaster, and the output number field is set
to 1).
Switcher Level 3 Keyer 3 (internal logo source)
Switcher Level 4 Keyer 4 (internal logo source)
Switcher Level 5 Keyer 5 (internal logo source)
Switcher Level 6 Keyer 6 (internal logo source)
Switcher Level 7 DVE/Squeezeback engine
Switcher Level 8 Voice-Over Mixer
Table 7-2. swr.tbl Mapping
Table 7-3. Mapping of bus.tbl switcher Fields to D-MAS Switching Levels
bus.tbl field D-MAS switching level
Switcher number A Audio and V – Video
DSK 1 switcher number D1 – Over Video 1
DSK 2 switcher number D2 – Over Video 4
DSK 3 switcher number D3 – Over Video 5
DSK 4 switcher number D4 – Over Video 6
Logo switcher number L1 – Over Video 2 (aka L or Logo)
Logo 2 switcher number L2 – Over Video 7
Audio over 1 switcher number O – Over Audio
Audio over 2 switcher number O2 – Over Audio 2
Effect switcher number E – Over Video 3 (aka Effect)
To Next Page
Loading...