Harris IconMaster - Page 193

IconMaster Installation and Configuration Manual 177
Chapter 8: Configuring IconMaster
• Logo Key 3 through Logo Key 6 states and/or contents (not available with
IconMaster Lite license)
• Aux bus functions
• Transition functions
To configure a Quick Select:
1. Choose whether you will recall the PST state or the PGM state.
Regardless of which state you will recall, the complete set of data is stored.
• Recall Saved PST State: Recalls whatever is on the Preset monitor at
the time that the Quick Select is made
• Recall Saved PGM State: Recalls whatever is on the Program monitor
at the time when the Quick Select is made
The PST/PGM state selection is a global selection that is made for all Quick
Selects.
2. Go through the four tabs of the Quick Selects dialog box, making selections
for Quick Selects 1-8. Each row in the table represents a single Quick
Select.
The contents of these tabs are described in the following sections.
• “Quick Selects for External Keys” on page 178
• “Quick Selects for Internal Logo Keys” on page 178
• “Quick Selects for Aux Buses” on page 180
• “Quick Selects for Transitions” on page 180
By default, all options on these tabs are selected, except for the Auto Take
option on the Transitions tab.
3. When you are satisfied with your Quick Selects choices, save and upload to
your IconMaster frame.
Back at your Control Panel, after the revised ICU file has been uploaded, when
you store and recall Quick Selects, the snapshots that are captured will reflect
the settings made on these screens.