180 IconMaster Installation and Configuration Manual
Chapter 8: Configuring IconMaster
If you select the Allow On-air Changes to Keyers check box, when the data
stored in this Quick Select is recalled, the keyers will be updated on the PGM
monitor. If this check box is not selected, Then when the Quick Select is
recalled, the contents of the keys that are currently on the PGM monitor will not
change. This will not change the state of the keys, though, and the keys can still
come off air. This setting is a global setting that applies to all Quick Selects, for
example to protect station branding.
Quick Selects for Aux Buses
For each Quick Select, you can choose to recall the contents of any or all of the
12 Aux buses.
To avoid excess router switching traffic during a quick select recall,
deselect all unnecessary Aux busses in quick selects that are in
use.
Figure 8-18. Aux Bus Keys Quick Select Dialog Box
Click Select All to select all the Aux Buses for that particular Quick Select.
Click Select All again to unselect all the Aux Buses.
Quick Selects for Transitions
The Transition tab of the Quick Select Configuration dialog box has options
To Next Page
Loading...