42 IconMaster Installation and Configuration Manual
Chapter 2: Installation
Table 2-4. MKA-3901 AES Output Connector Pinouts
This information is for use when it is necessary to wire directly to the AES output connector. If you are using the
ICONM-BO-VAC or ICONM-BO-VAB breakout module, this information is not required.
Pin Function Pin Function Pin Function
1 Reserved for future use 22 Ground 43 Reserved for future use
2 Reserved for future use 23 N/C 44 Reserved for future use
3 Ground 24 Ground 45 Ground
4 AES Pgm 3 (B+) 25 Ground 46 AES Pgm 2 (B+)
5 AES Pgm 3 (B-) 26 AES Pgm 4 (B+) 47 AES Pgm 2 (B-)
6 Ground 27 AES Pgm 4 (B-) 48 Ground
7 AES Pst 1 (B+) 28 Ground 49 AES Pst 2 (B+)
8 AES Pst 1 (B-) 29 AES Pgm 1 (B+) 50 AES Pst 2 (B-)
9 Ground 30 AES Pgm 1 (B-) 51 Ground
10 AES Pst 3 (B+) 31 Ground 52 AES Pst 4 (B+)
11 AES Pst 3 (B-) 32 AES Clean 2 (B+) 53 AES Pst 4 (B-)
12 Ground 33 AES Clean 2 (B-) 54 Ground
13 AES Clean 1 (B+) 34 Ground 55 AES Clean 4 (B+)
14 AES Clean 1 (B-) 35 AES Clean 3 (B+) 56 AES Clean 4 (B-)
15 Ground 36 AES Clean 3 (B-) 57 Ground
16 AES Mon 1 (B+) 37 Ground 58 AES Mon 2 (B+)
17 AES Mon 1 (B-) 38 Ground 59 AES Mon 2 (B-)
18 Ground 39 Ground 60 Ground
19 AES Mon 3 (B+) 40 Ground 61 AES Mon 4 (B+)
20 AES Mon 3 (B-) 41 Ground 62 AES Mon 4 (B-)
21 Ground 42 Ground
For balanced data, use B+ and B-. For unbalanced (coax), use B+ for the signal and connect B- to ground (shield). To
use the coax, the C version of the card must be purchased.
42
21
62
20
41
61
19
40
60
18
39
59
17
38
58
16
37
57
36
15
56
14
35
55
13
34
54
12
33
53
11
32
52
10
31
51
30
9
50
8
29
49
7
28
48
6
27
47
5
26
46
4
25
45
24
3
44
2
23
43
1
22
To Next Page
Loading...