IconMaster Installation and Configuration Manual 81
Chapter 4: Router Connections
6. Press the right (Enter) button.
7. Use the toggle switch (Nav) to scroll through the parameter list until
IP_Address is highlighted.
8. Press the right (Enter) button.
9. Continue pressing the right (Enter) button until the cursor is under the digit
you want to change.
10. Use the toggle switch (Nav) to change the digit.
11. Press the right (Enter) button to move to the next digit.
12. Repeat the previous three steps until you have changed the IP address.
13. Press the right (Enter) button until the cursor is under the space at the end
of the IP address.
14. Press the left (Esc) button to accept the change.
4. Set the IP Address for the MGI-3903 Module
1. Press the left (Esc) button until the message MGI-3903-R appears on the
VFD display.
2. Press the right (Enter) button.
3. Use the toggle switch (NAV) to scroll through the parameter list until
IP_Address is highlighted.
4. Press the right (Enter) button.
5. Continue pressing the right (Enter) button until the cursor is under the digit
you want to change.
6. Use the toggle switch (Nav) to change the digit.
7. Press the right (Enter) button to move to the next digit.
8. Repeat the previous three steps until you have changed the IP address.
9. Press the right (Enter) button until the cursor is under the space at the end
of the IP address.
10. Press the left (Esc) button to accept the change.
11. Using the IconMaster configuration utility software, set the MKE-3901
reference mode to Composite. (See the IconMaster Configuration Utility
Software Reference Guide for more information.)
Changing the Control Panel IP Address
1. Access the Service Menu.
2. Turn the left scroll knob until the PNL IP ADDR parameter appears.
Reading from left to right, you will see a display of the control panel’s
current IP address.
3. Select the button that contains the IP address component that you want to
change, and then turn the right scroll knob to change the number on that
button.
4. After you enter the last digit of the IP Address, press the right knob to save
the new IP Address.
To Next Page
Loading...