HP 262SA - Paper Movement; Record Mode

Peripheral Devices
PAPER MOVEMENT
Two paper movement operations are allowed: line feed (advance line) and form feed (advance
page).
To
perform one of these operations using the function keys, press the Band
device control keys, in sequence. Then press either the ADVANCE LINE or ADVANCE PAGE
key, as desired. Pressing the ADVANCE LINE key sends an ASCII <CR> <LF> control code
sequence to the printer. Pressing the ADVANCE PAGE key sends an ASCII <FF > control code to
the printer.
Programmatically, you can produce a printer line feed by sending the following escape se-
quence:
Ec&p1c4u1P
The number preceding the ttp", in the escape sequence, specifies how many line feeds you
want. For example, to generate four successive line feeds, preceed the ttp" with the number
tt4". Refer to Appendix A for a complete explanation of this escape sequence.
To produce a form feed from a program, send the terminal the following escape sequence:
Ec&pOc4U
(The values 2 through 10, preceding the ttc" in the escape sequence, will also produce a form
feed.)
RECORD MODE
In Record mode, data is copied from the display (in Local mode) or from the computer (in
Remote mode)
to the selected ttto" devices. In Remote mode, the data stream from the com-
puter is also stored in terminal memory and displayed as it is stored, provided the screen is
selected as a tto device'.
To initiate Record mode using the function keys, press the following keys, in sequence:
B, device control, device modes, RECORD MODE
An asterisk is present in the RECORD MODE key label when Record mode is active. Alternate
presses of the key display and delete the asterisk. While in Record mode, the keyboard is
disabled, except for
the n, _, and RECORD MODE keys. The lei key is disabled after one
press.
To initiate Record mode programmatically, send the terminal the following escape sequence:
Ec&p<char>p20C
6-8