HP 262SA - Terminal Secondary Status Bytes

Status
SECONDARY STATUS BYTES
BYTE 7 BUFFER MEMORY
1K bytes
2K bytes
'----4K bytes
L....----8K bytes
Memory installed in addition to display memory that is
available for use as data buffers (Always 0).
BYTE 9
CONFIGURATION STRAPS J-M
Strap J (Auto Terminate
1 = yes (Enabled)
o = no (Disabled)
Strap K (Clear Terminator)
1
= yes (Enabled)
o = no (Disabled)
Strap L (Self Test Inhibit)
1 = yes (Inhibit test)
o = no (Allow test)
'------Strap M
Strap M does not apply to the terminal.
BYTE 8 TERMINAL FIRMWARE CONFIGURATION BYTE 10
(always five)
110 firmware installed
o No APL Firmware
Terminal
identifies
self
'------0 Non-programmable
terminal
CONFIGURATION STRAPS N-R
Strap N (Printer Escape
Code Transfer)
1 open (Send
ESC
code)
o closed (Do not send
code)
Strap P Compatibility
Mode (Scaled)
1 Enabled
o = Disabled
Strap a Compatibility
Mode (Unsealed)
1 Enabled
o = Disabled
------Strap R
a P
o 0 Compatibility Mode off
o 1 Scaled Compatibility
mode
o Unsealed Compatibility
mode
Compatibility Mode off
Figure 8-4. Terminal Secondary Status Bytes
8-9