HP 262SA - Escape Codes

Escape Codes
To set configuration parameters using escape codes, you must use an Ec &k, Ec &s, or Ec )
sequence, depending upon which parameters you wish to set.
Parameter Name
As Shown in Menu
LocalEcho
Caps Lock
SPOW
XmitFnctn(A)
SPOW(B)
InhEoIWrp(C)
Line/Page(D)
InhHndShk(
G)
Inh DC2(H)
Type of Escape
Sequence Used
Ec &k
Ec &s
The Ec &k and Ec &s sequences alter the particular parameter in the menu, but they do not
alter the content of non-volatile memory.
If a configuration menu is displayed on the screen when the escape sequence is received, the
sequence is stored in the terminal's datacomm buffer, and is not executed until the menu is
cleared from
the screen.
As
an exampleofescapecode use, youcanchange the valuesof the cCLocal Echo", cCCaps Loc k",
and CCSPOW" parameters using an escape sequence of the following form:
LocalEcho
= No:
Ec
&k
OL
LocalEcho = Yes:
Ec
&k
1L
Caps Lock = No:
Ec
&k
OC
Caps Lock = Yes:
Ec &k 1C
SPOW
Ec
&k
ON
Ec
&k
1H
You may combine these and other Ec &k parameters within one escape sequence. If you do, the
final identifier (such as L or C or N) must be uppercase and all preceding identifiers must be
lowercase. For example, to set Local Echo=Yes and Caps Lock =Yes, you could use either of the
following escape sequences:
Ec &k 11 1C
Ec &k 1c 1L
A-2