HP 262SA - Page 121

Data Communications
Table 7-3 provides a brief description of the cables useable for point-to-point configuration.
Table 7-3. Point-to-Point Cables
CABLE NO.
HP PART NO. DESCRIPTION
13242M
13242-60002 EUROPEAN MODEM CABLE
Male RS-232C 25-pin connector for
interfacing the terminal
to the European telephone system via Bell 103 or 202C type
European modems.
Length: 5
meters (16.7 feet)
13242N
13242-60001 U.S. MODEM CABLE
Male RS-232C 25-pin connector for
interfacing the terminal
to an HP 1000, 2000, or 3000 Multiplexer; to a Bell 103A,
202C/D/S/T, 212A, or VADIC 3400 modem; or to an acoustic
coupler (signal compatible only).
Length: 5
meters (16.7 feet)
13242P
13242-60013
Male RS-422 25-pin connector for
interfacing the terminal to
an HP 1000, HP 2000, or HP 3000 Multiplexer, in a hardwired
connection.
Length: 5
meters (16 feet)
13242X
13242-60019
Male RS-232-C 25-pin connector for
interfacing the terminal
to an HP 1000, HP 2000, or HP 3000 Multiplexer, in a
hardwired connection.
Length: 5
meters (16 feet)
13242Y
13242-60005
EMP PROTECT (MALE)
Male RS-232C 25-pin connector for
interfacing the terminal
to an HP 1000,2000, or 3000 Multiplexer. Provides protection
from lightning-induced
transients. For use in hardwired con-
figurations only.
Length: 5
meters (16.7 feet)
13232U
5061-2403
Modem bypass cable
with a female RS-232C 25-pin connector
on
both ends. It crosses the signals so that two terminals can
communicate with one another.
Length: 1.5
meters (5 feet)
7-9