102 Alphabetical list of commands
replicate snapshot
Description Initiates a replication operation using an existing snapshot as the data source. This command
replicates the specified external standard snapshot.
If the specified snapshot has not already been replicated on the replication volume, each replication
volume in the replication set is requested to replicate the snapshot data. Only snapshot preserved
data is replicated; snapshot modified data is not replicated.
If you instead want to create and replicate a snapshot as a single task, use the replicate volume
command.
Syntax
replicate snapshot
[name replication-snapshot]
[set replication-set]
external-snapshot
Parameters name replication-snapshot
Optional. A name for the resulting replication snapshot.
set replication-set
Optional. Name or serial number of the replication set.
external-snapshot
Name or serial number of the external snapshot to use as the data source. If the name is not unique
across replication sets, specify the set parameter.
Example Replicate external snapshot Snap1 and name the resulting replication snapshot RepSnap1:
# replicate snapshot name RepSnap1 Snap1
Success: Replication Initiated.
See also • show replication-sets
• show snapshots
To Next Page
Loading...
Need help?
General
