HP P2000 G3 MSA System CLI Reference Guide 27
The following commands have either been replaced by newer commands or removed.
API specific meta
set advanced-settings
show advanced-settings
show refresh-counters
Remote
systems
create remote-system
delete remote-system
remote
set remote-system
show remote-systems
verify links
verify remote-link
Remote
replication
abort replication
add replication-volume
create replication-set
delete replication-set
detach replication-volume
export snapshot
reattach replication-volume
remove replication-volume
replicate snapshot
replicate volume
resume replication
set replication-primary-volume
set replication-volume-parameters
show replication-images
show replication-sets
show replication-volumes
start vdisk
stop vdisk
suspend replication
Statistics reset all-statistics
reset controller-statistics
reset disk-error-statistics
reset disk-statistics
reset host-port-statistics
reset vdisk-statistics
reset volume-statistics
show controller-statistics
show disk-statistics
show host-port-statistics
show vdisk-statistics
show volume-statistics
Table 8 Replaced or removed commands
Old command New command
clear disk metadata clear disk-metadata
create host-name create host
create host-wwn-name create host
create iscsi-host create host
delete host-wwn-name delete host
delete iscsi-host delete host
expand master-volume expand volume
reset host-channel-link reset host-link
set drive-parameters set disk-parameters
set global-spare set spares
set host-port-interconnects None
set host-wwn-name set host-name
set iscsi-host set host-name
Table 7 Commands by category (continued)
Category Commands
To Next Page
Loading...
Need help?
General
