106 Alphabetical list of commands
reset controller-statistics
Description Resets performance statistics for controllers.
This command resets all controller statistics except Power On Time. To reset this, restart or power
cycle a controller.
Syntax
reset controller-statistics [a|b|both]
Parameters a|b|both
Optional. Specifies whether to reset statistics for controller A, B, or both. If this parameter is omitted,
statistics are reset for both controllers.
Example Reset statistics for both controllers:
# reset controller-statistics
Success: Command completed successfully.
See also • reset all-statistics
• reset disk-error-statistics
• reset disk-statistics
• reset host-port-statistics
• reset vdisk-statistics
• reset volume-statistics
• show controller-statistics
To Next Page
Loading...
