HP P2000 Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 209
show iscsi-parameters
Description For iSCSI, shows system-wide iSCSI parameters.
Syntax
show iscsi-parameters
Output CHAP
Whether Challenge-Handshake Authentication Protocol is enabled or disabled
Jumbo Frames
Whether jumbo-frame support is enabled or disabled
iSNS
Whether Internet Storage Name Service support is enabled or disabled
iSNS IP
Address of the iSNS server
iSNS Alt IP
Address of the alternate iSNS server
iSCSI Speed
Whether host port link speed is set to auto-negotiate (auto) or to 1 Gbit/sec
iSCSI IP Version
Whether iSCSI host port addresses use IPv4 or IPv6 format
Example Show system-wide iSCSI parameters:
# show iscsi-parameters
iSCSI Parameters
----------------
CHAP: Disabled
Jumbo Frames: Disabled
iSNS: Disabled
iSNS IP: 0.0.0.0
iSNS Alt IP: 0.0.0.0
iSCSI Speed: auto
iSCSI IP Version: 4
Basetypes • iscsi-parameters
• status
See also • set iscsi-parameters

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure