232 Alphabetical list of commands
show replication-volumes
Description Shows information about volumes in replication sets. You can view information about all replication
volumes, volumes in a specified replication set, or a specified replication volume.
Syntax
show replication-volumes
[set replication-set]
[replication-volume]
Parameters set replication-set
Optional. Name or serial number of the replication set.
replication-volume
Optional. Name or serial number of the replication volume. If the name is not unique within the
replication set, the local volume is assumed. If the name is not unique across replication sets, specify
the set parameter.
Output
Replication volume information:
Name
Replication volume name.
Serial Number
Replication volume serial number.
Status
Replication volume status: Detached, Establishing proxy, Inconsistent,
Initializing, Offline, Online, Replicate-Delay, Replicating, Suspended, or N/A.
After a secondary volume is reattached it has Establishing proxy status while establishing a proxy
connection with the remote (primary) system in preparation for replication.
Status-Reason
More information about the status value, or N/A for Online status.
Monitor
Replication volume monitoring status:
• OK: Communication to the remote volume is successfully occurring on the iSCSI network.
• Failed: Communication to the remote volume has failed because of an iSCSI communication
issue or because the remote volume has gone offline.
Location
Replication volume location: Local or Remote.
Primary-Volume
Primary volume name. If the replication set has a primary-volume conflict, all associated primary
volumes are displayed.
Primary-Volume-Serial
Primary volume serial number. If the replication set has a primary-volume conflict, all associated
primary volumes are displayed.
Primary-Volume-Status
Primary volume status: Online, Offline, Conflict, or N/A.
MaxQueue
Number of replication images to consider when determining the next image to replicate. Used only
if the On Collision parameter is set to Oldest.
MaxRetryTime
Amount of time in seconds that the replication volume should retry a replication operation on any
specific image when errors occur. Used only if the On Error parameter is set to Retry.
On Error
Error policy to invoke when errors occur during the replication process: Retry or Suspend.
To Next Page
Loading...
Need help?
General
