HP P2000 G3 MSA System CLI Reference Guide 185
show disk-parameters
Description Shows disk settings.
Syntax
show disk-parameters
Output SMART
Shows whether SMART is enabled or disabled for all disks, or is set to detect-only, which
specifies that each new disk inserted in the system retains its current SMART setting.
Drive Write Back Cache
Shows whether write-back cache for each disk in or added to the system will be enabled or disabled
after a rescan or controller restart. Don't Modify means that each disk’s current setting will not be
modified.
Timeout Retry Maximum
Maximum number of times a timed-out I/O operation can be retried before the operation is failed.
Attempt Timeout
Number of seconds before an I/O operation is aborted and possibly retried.
Overall Timeout
Total time in seconds before an I/O operation is failed regardless of the Attempt Timeout and
Number of Retries settings.
Drive Spin Down Non-Vdisk Enable
Shows whether DSD is enabled for available disks and global spares.
Drive Spin Down Non-Vdisk Delay
Shows the number of minutes after which inactive available disks and global spares automatically
spin down. If the delay is 0, DSD is disabled.
Example Show disk settings:
# show disk-parameters
Disk Parameters
-------------
SMART: Enabled
Drive Write Back Cache: Disabled
Timeout Retry Maximum: 3
Attempt Timeout: 8
Overall Timeout: 105
Drive Spin Down Non-Vdisk Enable: Disabled
Drive Spin Down Non-Vdisk Delay: 0
Basetypes • drive-parameters
• status
See also • set disk-parameters
To Next Page
Loading...
Need help?
General
