HP P2000

184 Alphabetical list of commands
show debug-log-parameters
Description For use by or with direction from a service technician.
Shows which debug message types are enabled (On) or disabled (Off) for inclusion in the Storage
Controller debug log.
Syntax
show debug-log-parameters
Output • awt: Auto-write-through cache triggers debug messages
• bkcfg: Internal configuration debug messages
• cache: Cache debug messages
• capi: Internal Configuration API debug messages
• capi2: Internal Configuration API tracing debug messages
• disk: Disk interface debug messages
• dms: Snapshot feature debug messages
• emp: Enclosure Management Processor debug messages
• fo: Failover/recovery debug messages
• fruid: FRU ID debug messages
• hb: Not used
• host: Host interface debug messages
• init: Not used
• ioa: I/O interface driver debug messages (standard)
• iob: I/O interface driver debug messages (resource counts)
• ioc: I/O interface driver debug messages (upper layer, verbose)
• iod: I/O interface driver debug messages (lower layer, verbose)
• mem: Internal memory debug messages
• misc: Internal debug messages
• msg: Inter-controller message debug messages
• mui: Internal service interface debug messages
• ps: Not used
• raid: RAID debug messages
• rcm: Removable-component manager debug messages
• res2: Internal debug messages
• resmgr: Reservation Manager debug messages
Example Show debug log parameters:
# show debug-log-parameters
Debug Log Parameters
--------------------
host: On
disk: On
mem: Off
...
Basetypes • debug-log-parameters
• status
See also • set debug-log-parameters