226 Alphabetical list of commands
show replication-images
Description Shows information about replication images for a specified replication volume.
Syntax
show replication-images
[set replication-set]
[replication-volume]
Parameters set replication-set
Optional. Name or serial number of the replication set.
replication-volume
Optional. Name or serial number of the replication volume. If the name is not unique within the
replication set, the local volume is assumed. If the name is not unique across replication sets, specify
the set parameter.
Output
Replication volume summary information:
Name
Replication volume name
Serial Number
Replication volume serial number.
Type
Replication volume type.
Replication volume image information:
Image Serial Number
Replication image serial number.
Image Name
User-defined name assigned to the primary image.
Snapshot Serial
Replication snapshot serial number associated with the image. The replication snapshot is associated
with the replication volume specified in the request.
Snapshot Name
Replication snapshot name associated with the image. For a secondary image, this value is not filled
in until the replication is completed.
Creation Date/Time
Date and time when the replication image was created on the replication volume.
Information shown for replication-volume images, not primary images:
Status
Status of the replication image: Complete, Create-Snapshot, Queued, Replicating,
Suspended, Offline, or Failed.
Progress
Percentage complete if the image is being replicated. Applies only to secondary volumes.
Start Date/Time
Date and time when replication started on the replication volume.
Last Update
Date and time when the image was last updated (either due to an ongoing replication operation or
the replication being completed).
Suspended
Date and time when the image was suspended or resumed.
To Next Page
Loading...
Need help?
General
