HP P2000 Reference Guide

76 Alphabetical list of commands
delete replication-set
Description Dissolves a replication set. The replication volumes associated with the replication set are converted
to master volumes and any replication snapshots associated with the replication volumes are
converted to standard snapshots. Snapshots are converted regardless of the number of snapshots
allowed by the system's license. This command must be run on the primary system.
Syntax
delete replication-set ID
Parameters ID
Name or serial number of either the replication set or its primary volume.
Example Delete replication set RS1:
# delete replication-set RS1
Success: Command completed successfully. (RS1) - Replication set deleted.
Delete the replication set with primary volume MV1:
# delete replication-set MV1
Success: Command completed successfully. (MV1) - Replication set deleted.
See also • show replication-sets
• show replication-volumes

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure