HP P2000

HP P2000 G3 MSA System CLI Reference Guide 215
show network-parameters
Description Shows the network settings for each controller module.
Syntax
show network-parameters
Output IP Address
Network port IP address
Gateway
Network port gateway IP address
Subnet Mask
Network port IP subnet mask
MAC Address
Controller’s unique Media Access Control address
Addressing Mode
• Manual: Network settings set manually (statically)
• DHCP: DHCP used to set network parameters
Example Show network parameters for a storage system using DHCP:
# show network-parameters
Network Parameters Controller A
-------------------------------
IP Address: 10.134.129.188
Gateway: 10.134.0.1
Subnet Mask: 255.255.0.0
MAC Address: 00:C0:FF:0A:A3:26
Addressing Mode: DHCP
Network Parameters Controller B
-------------------------------
IP Address: 10.134.129.189
Gateway: 10.134.0.1
Subnet Mask: 255.255.0.0
MAC Address: 00:C0:FF:0A:A3:14
Addressing Mode: DHCP
Show network parameters for a storage system using manual addressing:
# show network-parameters
Network Parameters Controller A
-------------------------------
IP Address: 172.22.1.200
Gateway: 172.22.1.1
Subnet Mask: 255.255.255.0
MAC Address: 00:C0:FF:0A:43:18
Addressing Mode: Manual
Network Parameters Controller B
-------------------------------
IP Address: 172.22.1.201
Gateway: 172.22.1.1
Subnet Mask: 255.255.255.0
MAC Address: 00:C0:FF:0A:43:26
Addressing Mode: Manual
Basetypes • network-parameters
• status