HP P2000

HP P2000 G3 MSA System CLI Reference Guide 267
show volume-maps
Description Shows mapping information for a specified volume or for all volumes.
Syntax
show volume-maps [volume]
Parameters volume
Optional. Name or serial number of the volume to show mappings for. For volume syntax, see
Command syntax on page 21. If this parameter is omitted, information for all volumes is shown.
Output Serial Number
Volume serial number
Name
Volume name
Ports
Controller host ports that the mapping applies to
LUN
LUN used to access the volume
Access
Type of host access to the volume:
• read-write
• read-only
• no-access
• not-mapped
Host-Port-Identifier
• FC and SAS: Host WWPN
• iSCSI: Host initiator node name (typically the IQN)
• all other hosts for the volume’s default mapping
Nickname
Host nickname, or blank if not set or for all other hosts
Profile
• Standard: The host allows LUN 0 to be assigned to a mapping.
• OpenVMS: The host does not allow LUN 0 to be assigned to a mapping.
• HP-UX: The host allows LUN 0 to be assigned to a mapping and uses Flat Space Addressing.
Example Show all volume mappings:
# show volume-maps
Volume View [Serial Number (SN) Name (v1) ] Mapping:
Ports LUN Access Host-Port-Identifier Nickname Profile
-----------------------------------------------------------------------
A1,A2,B1,B2 501 read-write all other hosts Standard
Volume View [Serial Number (SN) Name (v2) ] Mapping:
Ports LUN Access Host-Port-Identifier Nickname Profile
------------------------------------------------------------------
A1,B1 101 read-write 207000c0ff001121 Host2 Standard
A1 100 read-only 207000c0ff001122 Host1 Standard
not-mapped all other hosts Standard
Basetypes • volume-view
• status