HP P2000 G3 MSA System CLI Reference Guide 191
show enclosures
Description Shows information about the enclosures in the storage system. Full detail available in XML API output
only.
Syntax
show enclosures
Output Encl
Enclosure ID
Encl WWN
Enclosure WWN
Name
Enclosure name
Location
Enclosure location; blank if not set
Rack
Number of the rack containing the enclosure
Pos
Position of the enclosure in the rack
Vendor
Enclosure vendor
Model
Enclosure model
EMP # BUS:ID Rev
Address and firmware revision of the Enclosure Management Processor in each controller’s
Expander Controller
Midplane Type
• 2U24-6G: Midplane for 2U, 24-disk enclosure with 6-Gbps maximum data rate to disks
• 2U24-3G: Midplane for 2U, 24-disk enclosure with 3-Gbps maximum data rate to disks
• 2U12-6G: Midplane for 2U, 12-disk enclosure with 6-Gbps maximum data rate to disks
• 2U12-3G: Midplane for 2U, 12-disk enclosure with 3-Gbps maximum data rate to disks
• N/A: Other type of midplane
Example Show information about the enclosures:
# show enclosures
Encl Encl WWN Name Location Rack Pos Vendor Model
EMP A CH:ID Rev EMP B CH:ID Rev Midplane Type
------------------------------------------------------------------
1 WWN Controller Lab 0 4 vendor model
01:031 1115 00:031 1115 2U24-3G
-----------------------------------------------------------------
Basetypes • enclosures
• status
See also • set enclosure
• show sensor-status
To Next Page
Loading...
Need help?
General
