HP P2000 Reference Guide

206 Alphabetical list of commands
show host-port-statistics
Description Shows performance statistics for each controller host port.
Syntax
show host-port-statistics [ports ports]
Parameters ports ports
Optional. The controller ID and port number of ports to show information about. For port syntax, see
Command syntax on page 21. If this parameter is omitted, information is shown for all host ports.
Output Durable ID
Host port ID in the form hostport_controller-ID-and-port-number.
Bytes per second
Data transfer rate calculated over the interval since these statistics were last requested or reset. This
value will be zero if it has not been requested or reset since a controller restart.
IOPS
Input/output operations per second, calculated over the interval since these statistics were last
requested or reset. This value will be zero if it has not been requested or reset since a controller
restart.
Number of Reads
Number of read operations since these statistics were last reset or since the controller was restarted.
Number of Writes
Number of write operations since these statistics were last reset or since the controller was restarted.
Data Read
Amount of data read since these statistics were last reset or since the controller was restarted.
Data Written
Amount of data written since these statistics were last reset or since the controller was restarted.
Queue Depth
Number of pending I/O operations currently being serviced.
Example Show host-port statistics:
# show host-port-statistics
Durable ID Bytes per second IOPS Number of Reads Number of Writes
Data Read Data Written Queue Depth
-----------------------------------------------------------------------------
hostport_A1 98.7MB 1507 342177010 43779180696
254.6GB 32.5TB 33
-----------------------------------------------------------------------------
Basetypes • host-port-statistics
• status
See also • reset all-statistics
• reset host-port-statistics
• show controller-statistics
• show disk-statistics
• show vdisk-statistics
• show volume-statistics
• show host-port-statistics
• show ports

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure