254 Alphabetical list of commands
show tasks
Description Shows information about all tasks.
Syntax
show tasks
Output For a TakeSnapshot task:
Task Name
Task name
Task Type
TakeSnapshot
Status
• Uninitialized: Task is not yet ready to run
• Ready: Task is ready to run
• Active: Task is running
• Error: Task has an error
• Invalid: Task is invalid
Task State
Current step of the task:
• Start
• VerifyVolume
• ValidateLicensingLimit
• CreateName
• CreateSnap
• VerifySnap
• InspectRetention
• FindOldestSnap
• UnmapSnap
• ResetSnap
• RenameSnap
Error Message
Message if an error occurred while processing the task, or blank
Source Volume
Standard or master volume name
Source Volume Serial
Volume serial number
Prefix
Label that identifies snapshots created by this task. Snapshot names have the format prefix_s#,
where # starts at 001.
Count
Number of snapshots to retain with this prefix. When a new snapshot exceeds this limit, the oldest
snapshot with the same prefix is deleted.
Last Created
Name of the last snapshot created by the task, or blank
Snapshot Name
Name of each snapshot taken, or blank
Snapshot Serial
Serial number of each snapshot taken, or blank
To Next Page
Loading...
Need help?
General
