HP P2000 Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 253
For a DisableDSD task:
Task Name
Task name, which must be taskDSDsuspend
Task Type
DisableDSD
Status
• Uninitialized: Task is not yet ready to run
• Ready: Task is ready to run
• Active: Task is running
• Error: Task has an error
• Invalid: Task is invalid
Task State
Current step of the task; always Start
Error Message
Message if an error occurred while processing the task, or blank
Example Show information about task Snap:
# show task-details Snap
Tasks
-----
Task Name: Snap
Task Type: TakeSnapshot
Status: Ready
Task State: Start
Error Message:
Task Details
------------
Source Volume: MV
Source Volume Serial: SN
Prefix: MV
Count: 1
Last Created: MV_S0001
Snapshot Name Snapshot Serial
------------------------------------------------------
MV_S0001 SN
Basetypes • tasks
• status
See also • create schedule
• create task
• delete task
• set task
• show schedule-details
• show schedules
• show tasks

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure