HP P2000 Reference Guide

276 Alphabetical list of commands
suspend replication
Description Suspends the current replication operation on the specified replication volume. This command must
be issued on the system that owns the secondary volume. Once suspended, the replication must be
resumed or aborted to allow the replication volume to resume normal operation.
Syntax
suspend replication
[set replication-set]
replication-volume
Parameters set replication-set
Optional. Name or serial number of the replication set
replication-volume
Name or serial number of the replication volume. If the name is not unique across replication sets,
specify the set parameter.
Example Suspend replication on replication volume MV2:
# suspend replication MV2
Success: Replication Suspended.
See also • abort replication
• resume replication
• show replication-sets
• show replication-volumes

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure