HP P2000 Reference Guide

246 Alphabetical list of commands
show snmp-parameters
Description Shows SNMP settings for event notification.
Syntax
show snmp-parameters
Output SNMP Trap Notification Level
• crit: Only Critical events are sent as traps
• error: Error and Critical events are sent as traps
• warn: Warning, Error, and Critical events are sent as traps
• info: All events are sent as traps
• none: No events are sent as traps and traps are disabled
SNMP Trap Host IP#
IP address of each trap host
SNMP read community
Community string for read-only access (not shown to Monitor users)
SNMP write community
Community string for write access (not shown to Monitor users)
Example Show SNMP notification settings:
# show snmp-parameters
SNMP Trap Notification Level: crit
SNMP Trap Host IP1: 172.22.4.171
SNMP Trap Host IP2: 0.0.0.0
SNMP Trap Host IP3: 0.0.0.0
SNMP read community: public
SNMP write community: private
Basetypes • snmp-parameters
• status
See also • set snmp-parameters
• set protocols
• show protocols

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure