HP P2000 Reference Guide

42 Alphabetical list of commands
convert std-to-master
Description Converts a standard volume to a master volume; that is, it enables the volume for snapshots and
associates it with an existing snap pool. The standard volume and the snap pool must be owned by
the same controller, though they can be in different vdisks.
Syntax
convert std-to-master
snap-pool snap-pool
standard-volume
Parameters snap-pool snap-pool
Name or serial number of the snap pool to associate with the new master volume. For volume syntax,
see Command syntax on page 21.
standard-volume
Name or serial number of the standard volume to convert. For volume syntax, see Command syntax
on page 21.
Example Convert standard volume V1 to a master volume and associate it with snap pool SP1:
# convert std-to-master snap-pool SP1 V1
Success: Command completed successfully. - The conversion of a standard volume
to a master volume completed.
See also • show volumes

HP P2000 Specifications

General

Drive Support	SAS
Controller	Dual Controller options available
Host Interface	6Gb SAS, 8Gb FC, 1Gb iSCSI
RAID Levels	RAID 0, 1, 5, 6, 10
Storage Type	SSD
Hot-swappable Components	Drives, controllers, power supplies, fans
Dimensions	8.9 x 44.8 x 63.5 cm (3.5 x 17.6 x 25 inches)
Drive Bays	Up to 12 LFF or 24 SFF drive bays per enclosure